Builders Edge 130110003078 Guía de instalación

Busca en linea o descarga Guía de instalación para No Builders Edge 130110003078. Builders Edge 130110003078 Installation Guide Manual de usuario

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 2
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 0
Slim Line Master Mount
Installation Instructions
-To be installed prior to siding-
Step 1
Remove the trim ring from the Slim Line Master Mount Assembly.
See Figure 1 at right.
Figure 1
Step 3
Center the Slim Line Master Mount over the outlet box. Be sure to
place tape or sealant between the Slim Line Master Mount and the
house. Attach the Slim Line Master Mount securely using an 8d nail
or equivalent with a minimum of four attachments. See Figure 3 at
right. Note: The sheathing on the illustration at right has been
removed for clarity. The outlet box should be in contact with the
under side of the Slim Line Master Mount.
Note: The use of a box extension (supplied by others) may be
required by your local or state electrical codes. Alternatively,
the box can be repositioned so that it contacts the underside
of the Slim Line Master Mount.
CAUTION: All electrical connections must be in accordance with state
and local codes, ordinances, and the National Electrical Code. If you
are unfamiliar with methods of installing electrical wiring and devices,
secure the services of a qualified licensed electrician.
I-0081
PAPC 9560
6/20/02
Step 2
Cut the desired opening in the Slim Line Master Mount by cutting
along the patterns provided on the back of the part. See Figure 2
at right.
Figure 2
Note: Common sense, caution and care are factors which cannot be built into any product.
These conditions must be supplied by the person(s) installing the fixture.
Figure 3
ELEC.
BOX
BOX
EXTENSION
(IF USED)
SLIM LINE
MASTER
MOUNT
STUD
Vista de pagina 0
1 2

Indice de contenidos

Pagina 1 - Slim Line Master Mount

Slim Line Master MountInstallation Instructions-To be installed prior to siding-Step 1 Remove the trim ring from the Slim Line Master Mount Assembly.

Pagina 2 - Figure 6

Step 4Cut the siding around the Slim Line Master Mount. Install the siding according to the manufacturer's installation instructions. See Figur

Comentarios a estos manuales

Sin comentarios